Diagnostic
Cause: Possible mechanical damage such as bent connecting rods, especially if the engine was running when it submerged Test: Attempt to crank the engine by hand after recovery procedure is complete
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 30 minutes conditions={"context":"If engine starts and no mechanical damage is evident"}
Procedure · 1. Remove the engine cover (refer to p. 88) and rinse the outboard motor with fresh water to remove salt water, sand, mud, etc. WARNING: A submerged outboard motor must be serviced immediately after recovery to minimi...
Spec · 2 inches (5 cm) conditions={"context":"Required during engine start and extended run after submersion"}
Procedure · 6. Attempt to start the engine. Ensure the water level is at least 2 inches (5 cm) above the antiventilation plate before running. WARNING: Running the outboard motor without sufficient cooling water will damage the w...
Diagnostic · Cause: Wet/flooded spark plugs Test: Remove spark plugs and inspect for moisture Expected: Dry spark plugs after removal and drying