Specification
Engine: Minimum engine run duration after post-submersion start
30 minutes conditions={"context":"If engine starts and no mechanical damage is evident"}
Specification
30 minutes conditions={"context":"If engine starts and no mechanical damage is evident"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 6. Attempt to start the engine. Ensure the water level is at least 2 inches (5 cm) above the antiventilation plate before running. WARNING: Running the outboard motor without sufficient cooling water will damage the w...
Diagnostic · Cause: Possible mechanical damage such as bent connecting rods, especially if the engine was running when it submerged Test: Attempt to crank the engine by hand after recovery procedure is complete
Spec · 2 inches (5 cm) conditions={"context":"Required during engine start and extended run after submersion"}
Procedure · 1. Idle the engine in neutral and check the cooling system indicator for water flow. 2. If water is flowing from the cooling system indicator, continue idling for 30 seconds. 3. Confirm the overheat indicator turns of...
Diagnostic · Cause: Wet/flooded spark plugs Test: Remove spark plugs and inspect for moisture Expected: Dry spark plugs after removal and drying