Specification
Antiventilation Plate / Cooling System: Minimum water level above antiventilation plate during operation
2 inches (5 cm) conditions={"context":"Required during engine start and extended run after submersion"}
Specification
2 inches (5 cm) conditions={"context":"Required during engine start and extended run after submersion"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 6. Attempt to start the engine. Ensure the water level is at least 2 inches (5 cm) above the antiventilation plate before running. WARNING: Running the outboard motor without sufficient cooling water will damage the w...
Diagnostic · Cause: Cooling system issue or overheating condition Test: Idle the engine in neutral and check the cooling system indicator for water flow
Spec · Level with the water surface conditions={"mode":"Normal cruising"}
Procedure · 1. Use the power trim/tilt switch (UP or DN side) to adjust the angle of the outboard motor. The switch can be used whether the boat is underway or stopped. 2. Refer to the trim meter (p. 44) for an indication of whet...
Diagnostic · Cause: Temporary overheating; cooling system otherwise functional Test: Continue idling for 30 seconds; overheat indicator should turn off and engine should respond normally to throttle control lever