Specification
Outboard Motor / Antiventilation Plate: Antiventilation plate trim position under normal conditions
Level with the water surface conditions={"mode":"Normal cruising"}
Specification
Level with the water surface conditions={"mode":"Normal cruising"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Use the power trim/tilt switch (UP or DN side) to adjust the angle of the outboard motor. The switch can be used whether the boat is underway or stopped. 2. Refer to the trim meter (p. 44) for an indication of whet...
Diagnostic · Cause: Excessive trim/tilt angle during operation
Spec · 2 inches (5 cm) conditions={"context":"Required during engine start and extended run after submersion"}
Procedure · 1. Use the power trim/tilt switch (see pages 75–76) to tilt the outboard motor up so the propeller and gear case clear the bottom. 2. Proceed at low speed. 3. Monitor water flow from the cooling system indicator (see ...
Diagnostic · Cause: Outboard motor trimmed or tilted up excessively, or propeller ventilation during a sharp turn Test: Check trim angle of outboard motor; verify correct propeller is installed