Engine will not start

Related KB links

• Operating Hour Notification System: Emergency stop switch clip cycles to reset hour counter

  Spec · 5 conditions={"timeWindow":"within 20 seconds"}

• Engine will not start – troubleshooting

  Procedure · 1. Insert clip in emergency stop switch. 2. Shift control lever to neutral position. 3. Leave fast idle lever in the OFF position (side-mount type only).

• Starter Motor: Max continuous starter motor operation

  Spec · 5 seconds conditions={"note":"Exceeding 5 seconds will overheat and damage the starter motor"}

• Starting the Engine via Ignition Switch (DBW Type, without START/STOP switch)

  Procedure · 1. Ensure the gearshift/throttle control lever is in the N (neutral) position (refer to p. 56). WARNING: Engine will not start if lever is not in neutral. 2. Confirm the emergency stop switch clip is inserted into the...

• Engine will not start

  Diagnostic · Cause: Emergency stop switch clip is not inserted in the emergency stop switch Test: Verify the emergency stop switch clip is fully seated in the emergency stop switch