Procedure
Engine will not start – troubleshooting
1. Insert clip in emergency stop switch. 2. Shift control lever to neutral position. 3. Leave fast idle lever in the OFF position (side-mount type only).
Procedure
1. Insert clip in emergency stop switch. 2. Shift control lever to neutral position. 3. Leave fast idle lever in the OFF position (side-mount type only).
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · N (Neutral) conditions={"requirement":"Required for engine start"}
Diagnostic · Cause: Gearshift/throttle control lever is not in the N (neutral) position, or the emergency stop switch clip is not inserted in the emergency stop switch Test: Verify lever is in neutral; verify emergency stop switch...
Spec · Below 41 °F (5°C) conditions={"trigger":"Engine started, outside temperature below threshold"}
Procedure · 1. Ensure the gearshift/throttle control lever is in the N (neutral) position (refer to p. 56). WARNING: Engine will not start if lever is not in neutral. 2. Confirm the emergency stop switch clip is inserted into the...
Diagnostic · Cause: Emergency stop switch clip is not inserted in the emergency stop switch Test: Verify the emergency stop switch clip is fully seated in the emergency stop switch