Engine will not start

Related KB links

• Operating Hour Notification System: Emergency stop switch clip cycles to reset hour counter

  Spec · 5 conditions={"timeWindow":"within 20 seconds"}

• Engine will not start – troubleshooting

  Procedure · 1. Insert clip in emergency stop switch. 2. Shift control lever to neutral position. 3. Leave fast idle lever in the OFF position (side-mount type only).

• Function Switch / Fast Idle Mode: Fast Idle Mode – Activation Temperature Threshold

  Spec · 41 °F (5°C) conditions={"condition":"Outside ambient temperature below threshold after engine start"}

• Pre-Start Safety Setup – Flush-mount Mechanical Wire Type Emergency Stop Switch

  Procedure · 1. Insert the emergency stop switch clip into the emergency stop switch, then attach the emergency stop switch lanyard securely to the operator or to the operator's PFD (Personal Flotation Device). WARNING: The engine...

• Engine will not start

  Diagnostic · Cause: Emergency stop switch clip is not inserted into the emergency stop switch Test: Verify clip is securely seated in the emergency stop switch