Difficulty planing off with aft livewells or heavy stern load

Related KB links

• Warning Horn: Warning horn duration (fault present)

  Spec · 1 beep(s) conditions={"trigger":"Key off and restart with fault still present","note":"Horn sounds one time only per key cycle"}

• Install Trim In (Tilt) Limit Pin

  Procedure · 1. Purchase a stainless steel tilt pin (17-49930A 1) from your dealer. 2. Select the desired adjustment hole in the transom brackets that limits the trim in angle to the preferred position. 3. Insert the stainless ste...

• Trim Tab: Trim tab adjustment effectiveness limit – antiventilation plate height above boat bottom

  Spec · 50 mm (2 in.) conditions={"note":"Trim tab adjustment will have little effect reducing steering torque if antiventilation plate is approximately 50 mm (2 in.) or more above the boat bottom"}

• After Each Use Service

  Procedure · 1. Flush out the outboard cooling system if operating in salt or polluted water. Refer to Flushing the Cooling System. 2. Wash off all salt deposits and flush out the exhaust outlet of the propeller and gearcase with ...

• Bow steering or oversteering while on plane

  Diagnostic · Cause: Engine trimmed too far under (in) while on plane — a condition called plowing Test: Observe boat attitude while on plane; if bow is down and steering is heavy or erratic, engine is over-trimmed in