Specification
50 mm (2 in.) conditions={"note":"Trim tab adjustment will have little effect reducing steering torque if antiventilation plate is approximately 50 mm (2 in.) or more above the boat bottom"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Operate the boat at normal cruising speed and trim position. 2. Turn the boat left and right and note the direction the boat turns more easily. 3. If adjustment is necessary, loosen the trim tab fastener. 4. Make s...
Diagnostic · Cause: Insufficient trim-under capability; may require greater transom angle or adjusted tilt pin position
Spec · First 20° conditions={"usage":"Operating the boat on plane"}
Procedure · 1. Purchase a stainless steel tilt pin (17-49930A 1) from your dealer. 2. Select the desired adjustment hole in the transom brackets that limits the trim in angle to the preferred position. 3. Insert the stainless ste...
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition