Procedure
1. Tilt the outboard to the full up position and engage the tilt support lever (a - Tilt support lever, b - Knob). 2. Remove the fill cap and check the fluid level. The fluid level should be even with the bottom of the fill hole. Add Quicksilver or Mercury Precision Lubricants Power Trim and Steering Fluid. If not available, use automotive automatic transmission fluid (ATF). Parts: Power Trim and Steering Fluid (92-858074K01)
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Even with the bottom of the fill hole
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition
Spec · First 20° conditions={"usage":"Operating the boat on plane"}
Procedure · 1. Check engine oil level. Refer to Fuel and Oil - Checking and Adding Engine Oil. 2. Check that lanyard stop switch stops the engine. 3. Inspect the outboard for tightness to the boat transom. Tighten mounting fasten...
Diagnostic · Cause: Excessive trim-in causing the bow to plow through water while on plane