Procedure
1. Remove the plug from the oil trough and attach a 12 mm (7/16 in.) I.D. drain hose to the fitting. Position the opposite end of the hose into an appropriate container. 2. Unscrew the old filter by turning the filter to the left (counterclockwise). 3. Allow oil in the trough to drain and remove the oil drain hose. 4. Clean any oil from the oil trough and install the plug. Tools: 12 mm (7/16 in.) I.D. drain hose, appropriate drain container
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 3/4 to 1 turn after gasket contacts base conditions={"gasket":"Film of clean oil applied, no grease"}
Diagnostic · Cause: Restricted fuel flow due to added components (filters, valves, fittings, etc.) in the fuel supply system Test: Inspect fuel supply system for any added restrictive components
Spec · Within cross-hatched region between bottom bar and top bar conditions={"note":"Do not attempt to fill to the top of the operating range; oil is correct as long as it appears anywhere within the cross-hatched region"}
Procedure · 1. Clean the oil filter mounting base. Apply a film of clean oil to the new filter gasket. Do not use grease. WARNING: Do not use grease on the filter gasket — use clean oil only. 2. Screw the new oil filter on until ...
Diagnostic · Cause: Fuel flow restriction caused by added components (filters, valves, fittings) in the fuel supply system