Procedure
1. Install cables into the remote control following the instructions provided with the remote control. WARNING: Install the shift cable to the engine FIRST. The shift cable is the first cable to move when the remote control handle is moved out of neutral. 2. Position the remote control and outboard into neutral position.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Copper only conditions={"note":"Aluminum power cables must not be used in any marine installation"}
Diagnostic · Cause: Shift cable barrel position too far from cable end Test: Shift remote control into forward and check if propeller shaft is locked in gear Expected: Propeller shaft locked in gear
Spec · 3.175 mm (0.125 in.) conditions={"context":"Accessory mounting plate must not rest in the radius of the transom clamp bracket","section":"Outboard Installation"}
Procedure · 1. Install cables into the remote control following the instructions provided with the remote control. 2. Shift remote control into the neutral (N) position. 3. Install the throttle cable onto the throttle cam anchor ...
Diagnostic · Cause: Cable barrel adjustment too close to the cable end Test: Shift remote control into reverse while turning propeller and check if propeller shaft locks Expected: Propeller shaft locked in gear