Specification
3.175 mm (0.125 in.) conditions={"context":"Accessory mounting plate must not rest in the radius of the transom clamp bracket","section":"Outboard Installation"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Ensure the accessory mounting plate does not rest in the radius of the transom clamp bracket. Maintain a minimum clearance of 3.175 mm (0.125 in.) between the edge of the accessory bracket and the transom clamp bra...
Diagnostic · Cause: Aftermarket accessories (e.g., boarding ladders, shallow water anchors, transom wedge kits, tow sport devices) mounted using the same fasteners that secure the outboard to the transom or jack plate, compromisin...
Spec · 2 full threads conditions={"note":"Locknut must be drawn tight while still engaging bolt threads and not contacting the shank of the bolt"}
Procedure · 1. Do NOT mount any accessory to the transom clamp bracket in an unsupported condition. See Figure 2 (ID: 54625). WARNING: Unsupported accessory mounting on the transom clamp bracket is not permitted. 2. Do NOT attach...
Diagnostic · Cause: Non-flat or stepped transom mounting surface exceeding 3.17 mm (0.125 in.) tolerance