Procedure
1. Remove the two top screws and loosen the two bottom screws. 2. Slide the shipping bracket off the bottom screws. 3. Tighten the bottom screws to the specified torque. (torque: 7.9 Nm) Tools: Flywheel Puller/Lifting Ring 91-895343T02
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 7.9 Nm conditions={"also":"70 lb-in"}
Diagnostic · Cause: Exhaust gas mixing with water over the propeller blades due to worn, loose, or damaged propeller bore sleeve Test: Inspect propeller bore sleeve when propeller is removed; check for wear, looseness, or broken r...
Spec · 70 lb-in
Procedure · 1. Before starting (cold engine), tilt outboard out/up past vertical to allow trapped oil to drain back to the oil sump. Allow outboard to remain tilted for approximately one minute. WARNING: Do not overfill. Check oi...
Diagnostic · Cause: Faulty lanyard stop switch Test: Start the engine and pull the lanyard cord; verify engine stops