Diagnostic
N/A - Engine does not stop when lanyard cord is pulled (N/A)
Cause: Faulty lanyard stop switch Test: Start the engine and pull the lanyard cord; verify engine stops
Diagnostic
Cause: Faulty lanyard stop switch Test: Start the engine and pull the lanyard cord; verify engine stops
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 122–152 cm conditions={"state":"stretched out","imperial_equivalent":"4–5 feet"}
Procedure · 1. Start the engine and pull the lanyard cord to verify the lanyard stop switch stops the engine. If the engine does not stop, have the switch repaired before operating the boat. WARNING: Do not operate the boat if th...
Spec · Within cross-hatched region between bottom bar and top bar conditions={"note":"Do not attempt to fill to the top of the operating range; oil is correct as long as it appears anywhere within the cross-hatched region"}
Procedure · 1. Turn the ignition key on. When the fuel pumps stop running, start the engine. 2. If the engine does not start on the first attempt, retry. The engine will run rough at idle for up to two minutes while residual air ...
Diagnostic · Cause: Lanyard stop switch not in RUN position