Procedure
1. If the boat is equipped with a SmartCraft and/or vessel (accessory) harness, remove the ignition coil cover located on the port side of the engine. Parts: Ignition coil cover, SmartCraft harness, Vessel (accessory) harness
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2 amp conditions={"fuse_label":"DIAG","fuse_number":"1"}
Diagnostic · Cause: Exhaust gas mixing with water over the propeller blades due to worn, loose, or damaged propeller bore sleeve Test: Inspect propeller bore sleeve when propeller is removed; check for wear, looseness, or broken r...
Spec · First 20° conditions={"usage":"Operating the boat on plane"}
Procedure · 1. Route the SmartCraft and/or vessel harness through the rigging grommet. 2. Connect the harness to the connector. Vessel (accessory) harness connects to connector (a); SmartCraft harness connects to connector (b).
Diagnostic · Cause: Blown 15 amp fuse — check 14 pin remote control harness/cowl trim switch/main power relay fuse