Cooling System Flush: Water tap setting (maximum)

Related KB links

• Flushing the Cooling System

  Procedure · 1. With the engine turned off, place the outboard in either the operating position (vertical) or in a tilted position. 2. Remove the flush connector from the bottom cowl. 3. Remove the cover from the flush connector a...

• No water flowing from the water pump indicator hole after engine start

  Diagnostic · Cause: Obstruction in the cooling water intake, water pump failure, or blockage in the cooling system Test: Visually inspect the water pump indicator hole for a steady stream of water after engine start; check cooling...

• Cooling System: Flush duration

  Spec · 15 minutes conditions={"water_tap_setting":"½ maximum"}

• Initial Engine Start / Starting Procedure

  Procedure · 1. Shift the outboard to the neutral (N) position. 2. Turn the ignition key to the START position and release the key. The electronic starting system will automatically crank the engine for starting. 3. If the engine ...

• Noncritical – intermittent short beeps for 6 seconds - Cooling system problem (water pressure or engine temperature)

  Diagnostic · Cause: Obstruction in water intake holes in lower unit Test: Stop engine and inspect water intake holes in lower unit for obstruction