Outboard mounting locknuts and bolts: Outboard mounting locknuts and bolts torque - standard boat transom

Related KB links

• Checking Boat Transom Construction

  Procedure · 1. Determine the strength of the boat transom before mounting the outboard. WARNING: The outboard mounting locknuts and bolts must be able to hold 75 Nm (55 lb-ft) of torque without the boat transom yielding or cracki...

• Loose engine mounting fasteners due to shared use of outboard fasteners for accessories

  Diagnostic · Cause: Aftermarket accessories (e.g., boarding ladders, shallow water anchors, transom wedge kits, tow sport devices) mounted using the same fasteners that secure the outboard to the transom or jack plate, compromisin...

• Outboard mounting fasteners: Outboard mounting locknuts and bolts torque - standard boat transom

  Spec · 75 Nm conditions={"transom_type":"standard boat transom","alternate_unit_lb_ft":"55.3"}

• Outboard Installation – Mounting Bolt Torque Procedure

  Procedure · 1. Apply marine sealer to the shank of the outboard mounting bolts (not the threads). WARNING: Do not apply marine sealer to the bolt threads. 2. Install 0.500 in. diameter outboard mounting bolts (x4) with 0.875 in. ...

• N/A - Bolt or nut continues to turn without torque reading increasing during transom mounting

  Diagnostic · Cause: Transom is yielding (insufficient structural strength) Test: Apply dial torque wrench to mounting bolt/nut and observe whether torque value increases with rotation