Specification
Propeller: Propeller selection target RPM
Upper half of recommended full throttle RPM range conditions={"load":"Boat normally loaded","reference":"General Information – Specifications"}
Specification
Upper half of recommended full throttle RPM range conditions={"load":"Boat normally loaded","reference":"General Information – Specifications"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Select a propeller that allows the engine to operate in the upper half of the recommended full throttle RPM range with the boat normally loaded (refer to General Information – Specifications). 2. If changing condit...
Diagnostic · Cause: Shift cable barrel position too far from cable end Test: Shift remote control into forward and check if propeller shaft is locked in gear Expected: Propeller shaft locked in gear
Spec · 2000 RPM conditions={"operation":"Shallow water tilt mode","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Procedure · 1. Switch to a lower pitch propeller. 2. Change the gear ratio if available. 3. Prop the engine to allow it to operate at or near the top end of the recommended maximum RPM range at wide-open throttle with a normal bo...
Diagnostic · Cause: Exhaust gas mixing with water over the propeller blades due to worn, loose, or damaged propeller bore sleeve Test: Inspect propeller bore sleeve when propeller is removed; check for wear, looseness, or broken r...