Specification
Propeller / Steering System: steering_torque_direction_trim_out
Pull to the left conditions={"trim_direction":"Trimmed out or up","installation":"Normal installation height","propeller_rotation":"Normal right-hand rotation"}
Specification
Pull to the left conditions={"trim_direction":"Trimmed out or up","installation":"Normal installation height","propeller_rotation":"Normal right-hand rotation"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Operate the boat at normal cruising speed and trim position. 2. Turn the boat left and right and note the direction the boat turns more easily. 3. If adjustment is necessary, loosen the trim tab fastener. 4. Make s...
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition
Spec · Pull to the right conditions={"trim_direction":"Trimmed in or down","propeller_rotation":"Normal right-hand rotation"}
Procedure · 1. Select a propeller that allows the engine to operate in the upper half of the recommended full throttle RPM range with the boat normally loaded (refer to General Information – Specifications). 2. If changing condit...
Diagnostic · Cause: Cable barrel adjustment too far from the cable end Test: Shift remote control to neutral and check if propeller shaft turns freely Expected: Propeller shaft turns freely without drag