Specification
Propeller / Steering System: steering_torque_direction_trim_in
Pull to the right conditions={"trim_direction":"Trimmed in or down","propeller_rotation":"Normal right-hand rotation"}
Specification
Pull to the right conditions={"trim_direction":"Trimmed in or down","propeller_rotation":"Normal right-hand rotation"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Store the outboard in an upright (vertical) position to allow water to drain out of the outboard. WARNING: Storing the outboard in a tilted position can damage the outboard. Water trapped in the cooling passages or...
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition
Spec · Pull to the left conditions={"trim_direction":"Trimmed out or up","installation":"Normal installation height","propeller_rotation":"Normal right-hand rotation"}
Procedure · 1. Select a propeller that allows the engine to operate in the upper half of the recommended full throttle RPM range with the boat normally loaded (refer to General Information – Specifications). 2. If changing condit...
Diagnostic · Cause: Cable barrel adjustment too far from the cable end Test: Shift remote control to neutral and check if propeller shaft turns freely Expected: Propeller shaft turns freely without drag