Specification
Steering Cable Nut: Steering Cable Nut Torque
35 lb-ft conditions={"side":"Starboard","routing":"Starboard Side Routed Cable","torque_Nm":"47.5","torque_lb_in":"–"}
Specification
35 lb-ft conditions={"side":"Starboard","routing":"Starboard Side Routed Cable","torque_Nm":"47.5","torque_lb_in":"–"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Lubricate the O-ring seal and entire cable end using 2-4-C with PTFE (Tube Ref No. 95, Part No. 92-802859A 1). 2. Insert the steering cable into the tilt tube. 3. Tighten the nut to the specified torque: 47.5 Nm / ...
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition
Spec · Tighten until it seats, then back off 1/4 turn conditions={"application":"Steering link rod to steering cable assembly"}
Procedure · 1. Rotate the steering wheel to fully retract the steering cable end into the outboard tilt tube. 2. Lubricate the steering cable grease fitting (if equipped) with 2-4-C with PTFE or Extreme Grease through the fitting...
Diagnostic · Cause: Engine trimmed too far under (in) while on plane — a condition called plowing Test: Observe boat attitude while on plane; if bow is down and steering is heavy or erratic, engine is over-trimmed in