Procedure
1. Lubricate the O-ring seal and entire cable end using 2-4-C with PTFE (Tube Ref No. 95, Part No. 92-802859A 1). 2. Insert the steering cable into the tilt tube. 3. Tighten the nut to the specified torque: 47.5 Nm / 35 lb-ft. (torque: 47.5 Nm) Parts: 2-4-C with PTFE Lubricant (92-802859A 1)
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 35 lb-ft conditions={"side":"Starboard","routing":"Starboard Side Routed Cable","torque_Nm":"47.5","torque_lb_in":"–"}
Diagnostic · Cause: Shift cable barrel position too close to cable end Test: Shift remote control into neutral and check if propeller shaft turns freely without drag Expected: Propeller shaft turns freely without drag
Spec · 2-4-C with PTFE or Extreme Grease conditions={"partNumbers":"92-802859A 1 / 8M0071842","tubeRefNo":"95"}
Procedure · 1. Rotate the steering wheel to fully retract the steering cable end into the outboard tilt tube. 2. Lubricate the steering cable grease fitting (if equipped) with 2-4-C with PTFE or Extreme Grease through the fitting...
Diagnostic · Cause: Cable barrel adjustment too far from the cable end Test: Shift remote control to neutral and check if propeller shaft turns freely Expected: Propeller shaft turns freely without drag