Specification
Steering Link Rod: Steering Link Rod Bolt Type
Special washer head bolt conditions={"partNumber":"10-856680","position":"a"}
Specification
Special washer head bolt conditions={"partNumber":"10-856680","position":"a"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Fasten the steering link rod (which connects the steering cable to the engine) using the special washer head bolt (Part Number 10-856680) and self-locking nylon insert locknuts (Part Number 11-826709113, positions ...
Diagnostic · Cause: Engine trimmed too far under (in) while on plane — a condition called plowing Test: Observe boat attitude while on plane; if bow is down and steering is heavy or erratic, engine is over-trimmed in
Spec · 27 Nm conditions={"also":"20 lb‑ft","application":"Steering link rod to engine assembly"}
Procedure · 1. Assemble the steering link rod to the steering cable using two flat washers and nylon insert locknut (c). Tighten the locknut until it seats, then back the nut off 1/4 turn. WARNING: Improper fasteners or improper ...
Diagnostic · Cause: Outboard trimmed so propeller shaft is not parallel to the water surface Test: Observe trim angle and adjust to neutral steering condition