Specification
Transom: Transom mounting surface flatness tolerance
3.17 mm (0.125 in.) conditions={"note":"No step in the transom mounting surface is allowed"}
Specification
3.17 mm (0.125 in.) conditions={"note":"No step in the transom mounting surface is allowed"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Use a dial torque wrench to determine transom strength. Tighten the mounting bolt or nut while monitoring the dial reading. 2. If the bolt or nut continues to turn without the torque reading on the dial increasing,...
Diagnostic · Cause: Non-flat or stepped transom mounting surface exceeding 3.17 mm (0.125 in.) tolerance
Spec · 3.17 mm (0.125 in.)
Procedure · 1. Ensure the accessory mounting plate does not rest in the radius of the transom clamp bracket. Maintain a minimum clearance of 3.175 mm (0.125 in.) between the edge of the accessory bracket and the transom clamp bra...
Diagnostic · Cause: Outboard mounted too high on transom — exceeds maximum mounting height for model Test: Measure mounting height: must not exceed 63.5 cm (25 in.) for L models or 76 cm (30 in.) for XL models