Operator ejected from position

Related KB links

• Outboard tilt mechanism: Shallow water drive release tilt angle

  Spec · ~15 degrees conditions={"operation":"Release from shallow water drive to run position"}

• Lanyard stop switch attachment and length adjustment

  Procedure · 1. Insert the lanyard element (plug end) fully into the lanyard stop switch. 2. Attach the lanyard cord clip to the operator's PFD or wrist. 3. If a shorter lanyard is desired, wrap the lanyard around the operator's w...

• Propeller Shaft: Propeller Shaft Lubricant Option 2

  Spec · Extreme Grease conditions={"purpose":"Prevent propeller hub from corroding to shaft"}

• Lanyard Stop Switch Pre-Use Inspection

  Procedure · 1. Before each use, start the engine and stop it by pulling the lanyard cord to verify the stop switch works properly. WARNING: If the engine does not stop when the lanyard cord is pulled, have the switch repaired bef...

• Engine does not stop when operator moves away from operator's position

  Diagnostic · Cause: Lanyard stop switch not activated or lanyard not properly attached to operator's PFD or wrist Test: Verify lanyard is clipped to operator's PFD or wrist and lanyard element is fully inserted into stop switch