Procedure
Lowering Outboard to Run Position
1. Raise the outboard and pull up on the tilt release lever. Gently lower the outboard down.
Procedure
1. Raise the outboard and pull up on the tilt release lever. Gently lower the outboard down.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · ~15 degrees conditions={"operation":"Release from shallow water drive to run position"}
Diagnostic · Cause: Improper installation of the outboard on the transom Test: Verify outboard is mounted per Mercury Marine validated fastener instructions and torque specifications
Spec · 6
Procedure · 1. Reduce engine speed to idle in forward gear. Take hold of the top cowl grip and raise the outboard to the higher tilt position. The spring loaded tilt lock lever will engage automatically and lock the outboard in t...
Diagnostic · Cause: Lanyard stop switch not activated or lanyard not properly attached to operator's PFD or wrist Test: Verify lanyard is clipped to operator's PFD or wrist and lanyard element is fully inserted into stop switch