Trim System: Trim Position

Related KB links

• Trim Angle Adjustment

  Procedure · 1. Arrange passengers and load in the boat so the weight is distributed evenly. 2. Set the tilt pin in the adjustment holes so the outboard runs perpendicular to the water at full speed, allowing the boat to run paral...

• Operator ejected from position

  Diagnostic · Cause: Accidental ejection activates lanyard stop switch Test: Verify lanyard is attached to operator's PFD or wrist before operation

• trim angle: trim_up

  Spec · Trim up conditions={"label":"c","description":"Bow raised; trim angle increased via higher trim position pin setting"}

• Adjust trim position pin to correct bow attitude

  Procedure · 1. Assess current trim angle while underway. Observe bow attitude relative to the water surface. 2. If the bow is entering the water (trim down / trim angle too small): water may enter the boat and speed will decrease...

• Engine does not stop when operator moves away from operator's position

  Diagnostic · Cause: Lanyard stop switch not activated or lanyard not properly attached to operator's PFD or wrist Test: Verify lanyard is clipped to operator's PFD or wrist and lanyard element is fully inserted into stop switch