Procedure
Release outboard from shallow water drive back to run position
1. Tilt outboard up slightly (approximately 15°). 2. Pull up on the tilt release lever. 3. Gently lower outboard down to the normal running position.
Procedure
1. Tilt outboard up slightly (approximately 15°). 2. Pull up on the tilt release lever. 3. Gently lower outboard down to the normal running position.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · ~15 degrees conditions={"operation":"Release from shallow water drive to run position"}
Diagnostic · Cause: Accidental ejection activates lanyard stop switch Test: Verify lanyard is attached to operator's PFD or wrist before operation
Spec · 1000 RPM conditions={"state":"After warming up","transmission":"In Neutral"}
Procedure · 1. Reduce engine speed to idle in forward gear. Take hold of the top cowl grip and raise the outboard to the higher tilt position. The spring loaded tilt lock lever will engage automatically and lock the outboard in t...
Diagnostic · Cause: Cooling water intake obstruction, water pump failure, or blockage in cooling system Test: Stop engine and check cooling water intake for obstruction