Diagnostic
Belt surfaces roughened
Cause: Belt wear or slippage Test: Visual and tactile inspection of belt surfaces
Diagnostic
Cause: Belt wear or slippage Test: Visual and tactile inspection of belt surfaces
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Inspect the accessory drive belt for any of the following conditions: cracks in the back of the belt or in the base of V grooves; excessive wear at the roots of the grooves; rubber portion swollen by oil; belt surf...
Procedure · 1. Remove the top cowl and flywheel cover. 2. Inspect the powerhead and powerhead components for salt buildup. 3. Wash off any salt buildup from the powerhead and powerhead components with fresh water. Keep water spra...
Diagnostic · Cause: Belt misalignment or wear Test: Visual inspection of belt edges and outer surfaces
Procedure · 1. Visually inspect the entire lanyard cord for any breaks, cuts, or wear. 2. Check that the clips on both ends of the cord are in good condition. 3. Replace any damaged or worn lanyard cords before operating the boat...
Diagnostic · Cause: Belt wear or misalignment Test: Visual inspection of belt groove roots