Diagnostic
Signs of wear on edges or outer surfaces of belt
Cause: Belt misalignment or wear Test: Visual inspection of belt edges and outer surfaces
Diagnostic
Cause: Belt misalignment or wear Test: Visual inspection of belt edges and outer surfaces
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Inspect the accessory drive belt for any of the following conditions: cracks in the back of the belt or in the base of V grooves; excessive wear at the roots of the grooves; rubber portion swollen by oil; belt surf...
Procedure · 1. Remove the top cowl and flywheel cover. 2. Inspect the powerhead and powerhead components for salt buildup. 3. Wash off any salt buildup from the powerhead and powerhead components with fresh water. Keep water spra...
Diagnostic · Cause: Belt wear or slippage Test: Visual and tactile inspection of belt surfaces
Procedure · 1. Verify the harnesses are not routed near sharp edges, hot surfaces, or moving parts. WARNING: Do not splice or probe into any wire insulation of the DTS system. Splicing or probing will damage wire insulation allow...
Diagnostic · Cause: Belt wear or misalignment Test: Visual inspection of belt groove roots