Engine Will Not Start

Related KB links

• Engine: Shallow Water Operation - Max Engine Speed (Tilted)

  Spec · 2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}

• Setting Trim Angle While Running Engine at Idle Speed

  Procedure · 1. Check if the exhaust relief hole on the outboard is submerged when the engine is trimmed full in while running at idle speed. WARNING: Submerged exhaust relief hole may result in exhaust restriction, rough idle, ex...

• Engine: Shallow Water Operation - Max Engine Speed (Entry)

  Spec · below 2000 RPM conditions={"mode":"Shallow water operation","note":"Reduce engine speed below 2000 RPM before tilting outboard up"}

• Protecting Internal Engine Components for Storage

  Procedure · 1. Refer to Maintenance – Spark Plug Inspection and Replacement for correct procedure for removing spark plugs. 2. Remove pencil coils and spark plugs. 3. Spray approximately 30 ml (1 fl oz) of Storage Seal Rust Inhib...

• Engine Runs Erratically

  Diagnostic · Cause: Spark plugs fouled or defective Test: Refer to Maintenance section