Procedure
Lubricate Trim Rod Ball Ends
1. Turn the ball ends to work the lubricant into the ball sockets.
Procedure
1. Turn the ball ends to work the lubricant into the ball sockets.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Tighten until seats, then back off 1/4 turn
Diagnostic · Cause: Excessive trim-in (trim under) causing the bow to plow into the water; unexpected turn can occur when any turn is attempted or a significant wave is encountered Test: Check trim angle; install stainless steel t...
Spec · 2000 RPM conditions={"mode":"Shallow water operation","note":"If engine speed exceeds 2000 RPM, outboard will automatically return down to maximum trim range"}
Procedure · 1. Lubricate trim rod ball ends with Extreme Grease (Part No. 8M0071842). Parts: Extreme Grease (8M0071842)
Diagnostic · Cause: Shift actuator failure Test: Turn ignition key switch off to reset and then start the engine