Specification
Nylon insert locknut: Nylon insert locknut thread size
½-20 conditions={"partNumber":"826711-17"}
Specification
½-20 conditions={"partNumber":"826711-17"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Do not install wedges or plates between the transom clamp brackets and the transom (or jack plate). WARNING: Installing wedges or plates between the transom clamp brackets and the transom or jack plate is prohibite...
Diagnostic · Cause: Use of common (non-locking) nuts instead of required self-locking nylon insert locknuts, or improper installation/torque procedures Test: Inspect fasteners for correct part numbers (10-849838 bolt, 11-826709113...
Spec · 27 Nm conditions={"also":"20 lb. ft."}
Procedure · 1. Apply marine sealer to the shank of the outboard mounting bolts (not the threads). 2. Install the four 0.500 in. diameter outboard mounting bolts with 0.875 in. flat washers, 1.500 in. flat washers, and nylon inser...
Diagnostic · Cause: Lanyard stop switch not properly attached or lanyard too long/slack Test: Verify lanyard is clipped to operator's PFD or wrist and inserted into switch; check lanyard length is 122–152 cm (4–5 ft) when stretched