Specification
Steering Link Rod - Nylon Insert Locknut d (11-826709113): Nylon insert locknut "d" torque
27 Nm conditions={"also":"20 lb. ft."}
Specification
27 Nm conditions={"also":"20 lb. ft."}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Assemble the steering link rod to the engine with special washer head bolt and self-locking nylon insert locknut. 2. First torque the bolt to specifications. 3. Then torque the locknut to specifications.
Diagnostic · Cause: Use of common (non-locking) nuts instead of required self-locking nylon insert locknuts, or improper installation/torque procedures Test: Inspect fasteners for correct part numbers (10-849838 bolt, 11-826709113...
Spec · Torque to specifications conditions={"note":"Torque locknut second, after bolt"}
Procedure · 1. Assemble the steering link rod to the steering cable using two flat washers and a self-locking nylon insert locknut (c). WARNING: Improper fasteners or improper installation procedures can result in loosening or di...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...