Specification
Pivot screw: Pivot screw torque
15 Nm conditions={"lb_in":"53"}
Specification
15 Nm conditions={"lb_in":"53"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Remove the pivot screw and flat washer from the rear cowl latch. 2. Pull out on the rear corner of the latch to clear the rear cover, then remove the rear cowl latch. WARNING: Ensure latch is fully cleared from the...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · 15 Nm conditions={"fastener":"screws (2)","lb_in":"53"}
Procedure · 1. Lubricate steering link rod pivot points.
Diagnostic · Cause: Wing nuts are not approved fasteners for battery terminals Test: Replace wing nuts with supplied 5/16 in. or 3/8 in. hex nuts; torque to 13.5 Nm (120 lb-in.)