Specification
3.175 mm (0.125 in.) conditions={"context":"Accessory mounting plate must not rest in the radius of the transom clamp bracket"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Ensure the accessory mounting plate does not rest in the radius of the transom clamp bracket, maintaining a minimum clearance of 3.175 mm (0.125 in.) — refer to Figure 1. WARNING: Installation must not create inter...
Diagnostic · Cause: Boat transom construction is inadequate to handle outboard mounting loads Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt and inspect transom for cracking or deformation Expected: No cracking or yi...
Spec · 0.125 in conditions={"note":"No step in the transom mounting surface is allowed"}
Procedure · 1. Mount the engine to the transom or jack plate in accordance with the engine installation instructions. 2. Identify unused bolt holes in the transom clamp bracket for accessory attachment (refer to Figure 1). 3. Ens...
Diagnostic · Cause: Boat transom is yielding under bolt torque; transom construction may not be adequate Test: Apply 75 Nm (55 lb-ft) torque to mounting locknut/bolt using a dial torque wrench and observe dial reading Expected: To...