Procedure
Daily Inspection – Throttle System
1. Check carburetor linkage is working normally when turning the throttle grip. Correct if abnormal.
Procedure
1. Check carburetor linkage is working normally when turning the throttle grip. Correct if abnormal.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Oil level must reach the bottom line of the plug hole conditions={"motorPosition":"Tilted up and locked with tilt stopper","tankPosition":"Vertical"}
Diagnostic · Cause: Abnormal condition or fault detected by outboard motor Test: Check warning lamp (LED) for synchronization; refer to fault condition table on following page
Spec · 1–10 min conditions={"throttlePosition":"Idle","phase":"1"}
Procedure · 1. Fuel System – Check the amount of fuel in the tank. Replenish as needed. WARNING: Do not use outboard motor if any abnormality is found during pre-operation check or it could result in severe damage to the motor or...
Diagnostic · Cause: Abnormal condition or fault detected by outboard motor Test: Check warning lamp (LED) for synchronization; refer to fault condition table on following page