Procedure
Daily Inspection – Tools and Spares
1. Check that tools and spare parts for replacing spark plugs, the propeller, etc. are on board. 2. Check that you have the spare rope.
Procedure
1. Check that tools and spare parts for replacing spark plugs, the propeller, etc. are on board. 2. Check that you have the spare rope.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Oil level must reach the bottom line of the plug hole conditions={"motorPosition":"Tilted up and locked with tilt stopper","tankPosition":"Vertical"}
Diagnostic · Cause: Corrosion of the anode causing bolts to loosen over time Test: Manual check and re-tightening of all anode attaching bolts at each inspection
Spec · 0 °C (32°F) conditions={"situation":"Mooring in cold weather","risk":"Water residue in pump may freeze and damage pump and impeller"}
Procedure · 1. Fuel System – Check the amount of fuel in the tank. Replenish as needed. WARNING: Do not use outboard motor if any abnormality is found during pre-operation check or it could result in severe damage to the motor or...
Diagnostic · Cause: Bent or damaged propeller blades Test: Check propeller for bent or damaged blades; replace propeller and retest