Specification
Anti-ventilation plate: Anti-ventilation plate depth below hull bottom
5–25 mm conditions={"alternate_unit":"0.2–1 in","reference":"Below bottom of hull"}
Specification
5–25 mm conditions={"alternate_unit":"0.2–1 in","reference":"Below bottom of hull"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Before beginning the running test, confirm the boat with maximum capacity loading floats in a proper attitude. 2. Check the position of the water surface on the driveshaft housing. The anti-ventilation plate should...
Diagnostic · Cause: Trim angle set too low Test: Observe hull attitude relative to water surface while underway Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · 0.2 in conditions={"reference":"Bottom of hull"}
Procedure · 1. Verify the boat's certification plate and ensure the outboard motor horsepower does not exceed the maximum allowable horsepower rating shown on the plate. WARNING: Do not equip your boat with an outboard motor that...
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface