Specification
Bolt: Bolt size – EP/EFT mounting
M8 x 85 mm conditions={"variant":"EP/EFT","quantity":"2"}
Specification
M8 x 85 mm conditions={"variant":"EP/EFT","quantity":"2"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Verify the boat's certification plate for maximum allowable horsepower; do not equip the boat with an outboard motor exceeding this limit. WARNING: Mounting an outboard motor that exceeds the boat's rated horsepowe...
Diagnostic · Cause: Galvanic corrosion consuming the sacrificial anode Test: Visual inspection of anode size relative to original dimensions
Spec · M8 x 85 mm conditions={"variant":"EPT","quantity":"4"}
Procedure · 1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer
Diagnostic · Cause: Corrosion of the anode causing bolts to loosen over time Test: Manual check and re-tightening of all anode attaching bolts at each inspection