Specification
MFS 6BZ: Steering Angle (MF)
90 degree conditions={"variant":"MF"}
Specification
90 degree conditions={"variant":"MF"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Stop the engine before adjusting the trim angle. WARNING: Do not put hand or finger between the outboard motor body and clamp bracket when adjusting trim angle — the outboard motor body may fall and cause injury. 2...
Diagnostic · Cause: Improper trim angle (excessive trim up or down) Test: Reduce speed immediately; stop boat and inspect thrust rod / priset knob position Expected: Thrust rod / priset knob positioned so hull runs horizontal
Spec · 70 degree conditions={"variant":"EF/EP"}
Procedure · 1. Make sure that the steering handle and remote control are functioning normally. Repair if abnormal.
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface