Specification
MFS 6BZ: Trim Angle (MF)
-8 to 12 degree conditions={"variant":"MF","transom_angle":"-12°"}
Specification
-8 to 12 degree conditions={"variant":"MF","transom_angle":"-12°"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Assess hull attitude during operation: the anti-ventilation plate should run parallel to the water surface and the hull should be horizontal. 2. If the bow rises too high above horizontal, set the thrust rod (or pr...
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface
Spec · -8 to 12 degree conditions={"transom_angle":"-12°"}
Procedure · 1. Stop the engine. 2. Raise the outboard motor manually. 3. Pull the preset knob to unlock. 4. Change the trim lock pin position: move pin to a higher hole to increase trim angle, or a lower hole to decrease trim ang...
Diagnostic · Cause: Trim angle set too high (excessive trim up) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface