Specification
MFS 8/9.8B: Overall Height (S)
1050 mm (41.3 in) conditions={"transom":"S (Short)"}
Specification
1050 mm (41.3 in) conditions={"transom":"S (Short)"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Before beginning the running test, confirm the boat with maximum capacity loading floats in a proper attitude. 2. Check the position of the water surface on the driveshaft housing. The anti-ventilation plate should...
Diagnostic · Cause: Fuel tank overfilled; air vent screw loose or open under high temperature conditions Test: Check fill level does not exceed tank capacity; ensure air vent screw is closed during transport/storage
Spec · 1050 mm (in: 41.3) conditions={"model":"MFS 8/9.8B","transom":"S"}
Procedure · 1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Lock the tilt stopper. 5. Change the trim lock pin position as shown in the picture: (1) Trim lock pin, (2) Higher, (3) Lower.
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface