MFS 8/9.8B: Transom Height (S)

Related KB links

• Trim angle adjustment – Power tilt type: Transom angle adjustment

  Procedure · 1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Lock the tilt stopper. 5. Change the trim lock pin position as shown in the picture: (1) Trim lock pin, (2) Higher, (3) Lower.

• Engine failing to start / Engine starting but stopping soon / Poor idling / Poor acceleration / Engine speed abnormally high / Engine speed abnormally low / Boat speed low / Overheating of engine / Warning lamp ON

  Diagnostic · Cause: Transom too high or too low

• MFS 8/9.8B: Transom Height (S)

  Spec · 435 mm (in: 17.1) conditions={"model":"MFS 8/9.8B","transom":"S"}

• Trim angle adjustment – Manual tilt (RC type): Transom angle adjustment

  Procedure · 1. Stop the engine. 2. Shift into forward. 3. Raise the outboard motor to the tilt up position. 4. Change the trim lock pin position using the preset knob: (1) Preset knob, (2) Pull, (3) Higher, (4) Lower. 5. Reinstal...

• Bow dips below horizontal during operation

  Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface