Specification
MFS 8/9.8B: Transom Height (S)
435 mm (in: 17.1) conditions={"model":"MFS 8/9.8B","transom":"S"}
Specification
435 mm (in: 17.1) conditions={"model":"MFS 8/9.8B","transom":"S"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. Stop the engine. 2. Shift into neutral position. 3. Tilt up the outboard motor. 4. Lock the tilt stopper. 5. Change the trim lock pin position as shown in the picture: (1) Trim lock pin, (2) Higher, (3) Lower.
Diagnostic · Cause: Transom too high or too low
Spec · 435 mm (17.1 in) conditions={"transom":"S (Short)"}
Procedure · 1. Use bolts (12 × 105) with small-diameter washers, nuts, and large-diameter washers to secure the outboard motor brackets on the transom board. Parts: Bolt (12 × 105), Washer (small diameter), Nut, Washer (large dia...
Diagnostic · Cause: Trim angle set too low (excessive trim down) Test: Observe hull attitude relative to horizontal water surface during slow-speed operation Expected: Hull horizontal; anti-ventilation plate parallel to water surface