Specification
Power Trim and Tilt Manual Relief Valve: Manual Relief Valve Tightening Torque
2 N·m conditions={"imperial":"1.5 ft·lb","metric_kgf":"0.2 kgf·m"}
Specification
2 N·m conditions={"imperial":"1.5 ft·lb","metric_kgf":"0.2 kgf·m"}
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisProcedure · 1. With the outboard motor installed on the boat, set the manual release valve to the MANUAL side, then tilt the outboard motor up and down manually 5–6 times. WARNING: Trapped air in the Power Tilt unit will cause po...
Diagnostic · Cause: Entrapped air in the Power Tilt unit Test: Perform air purging procedure: set manual release valve to Manual, tilt motor up/down 5–6 times manually, then close valve to Power side
Spec · 2 N·m conditions={"also":"1.5 ft·lb, 0.2 kgf·m"}
Procedure · 1. Before opening the manual relief valve, make sure nobody is under the outboard motor. If the outboard motor is in the tilted-up position with the manual relief valve loosened, the outboard motor will tilt down sudd...
Diagnostic · Cause: Battery is dead Test: Check battery charge; if dead, use the manual relief valve to allow manual tilting