Tohatsu MFS6/8/9.8B EFT/EPT: part_15

Related KB links

• Mounting the outboard motor – EPT type

  Procedure · 1. Set the outboard motor to the appropriate position. 2. Secure the clamp brackets to the transom board using bolts, flat washers, and nylon locking nuts. Parts: Bolt (8 × 85), Nylon locking nut, Flat washer

• ENOW00055-0 - Hand injury during tilt operation

  Diagnostic · Cause: Hand placed between swivel bracket and stern bracket while tilting up or down.

• Tohatsu MFS6/8/9.8B EFT/EPT: part_16

  Spec · Clamp Screw

• Mounting outboard motor to transom board (EP/EFT type)

  Procedure · 1. Drill holes in the transom board only at left and right of the lower side of the clamp bracket (2 holes total). WARNING: Do not reuse Nylon locking nut. 2. Apply sealing material (e.g. silicone sealant) between the...

• ENOW00048-0 - Injury from outboard motor body falling

  Diagnostic · Cause: Outboard motor tilted up or down while swimmer(s) or passenger is nearby; person caught between outboard motor body and clamp bracket.