Procedure
Engine Cover Installation
1. Place the engine cover on the main body. 2. Slide the engine cover so that the cover lock on the cover aligns with the lock in the main body.
Procedure
1. Place the engine cover on the main body. 2. Slide the engine cover so that the cover lock on the cover aligns with the lock in the main body.
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · Water cooling with thermostat
Diagnostic · Cause: Engine cover may require adjustment Test: Check fit at mid-case point after pushing all latches
Spec · 2000 rpm conditions={"ambientTemp":"Below 41°F (5°C)","method":"Push fast idle button, then move control lever forward or reverse"}
Procedure · 1. Unlock and remove the engine cover (refer to engine cover removal procedure, p. 88). 2. Attach the hoist hooks to the engine hangers. 3. Disconnect the outboard motor from the boat, hoist the outboard motor, and mo...
Diagnostic · Cause: Possible mechanical damage such as bent connecting rods, especially if the engine was running when it submerged Test: Attempt to crank the engine by hand after recovery procedure is complete