Procedure
1. Push the engine cover until any gap between the engine cover and main body is eliminated. 2. Push all the engine cover latches to lock them. WARNING: The cover should be tight at the mid-case point. If the cover is loose or difficult to secure, an adjustment may be necessary. See the shop manual or your Honda Marine dealer for adjustment. Tools: silicone spray (for lubricating the engine cover rubber sealing ring)
Open chat with this engine and topic preloaded so you can troubleshoot faster.
Ask Boat Guru about thisSpec · 2000 rpm conditions={"ambientTemp":"Below 41°F (5°C)","method":"Push fast idle button, then move control lever forward or reverse"}
Diagnostic · Cause: Engine cover may require adjustment Test: Check fit at mid-case point after pushing all latches
Spec · 20 degrees conditions={"direction":"either forward or reverse","note":"Further movement beyond 20° increases engine speed"}
Procedure · 1. Stop the engine and remove the engine cover (see p. 88). WARNING: Ensure the engine is fully stopped before removing the engine cover. 2. Confirm that there is no cooling water leakage from the engine. Tools: Castl...
Diagnostic · Cause: Lubrication system fault Test: Return to nearest boat landing and have outboard motor inspected by authorized Honda Marine dealer